![]() If you need to change them, you will have to create a new sketch window. Note: The contour and transom layout cannot be subsequently modified in this dialog box. If you pass your project as an archive document to another ARCHICAD user without an ArchiGlazing, the window can be opened and modified using ARCHICAD’s Window tool. The window will be updated automatically. Change the material settings for the profiles and glass surfaces and then click OK. Select the glass structure in your project and open ArchiGlazing from the Design > Design Extras menu. Note: Side frame additions are only possible with rectangular windows. ![]() In the Reveal Setup dialog box you can define whether the reveal should increase the window frame width or should reduce the aperture of the window. With this you ensure that the overall size of the aperture of the window created corresponds to the line contour specified by you. If you wish to position the window in the floor plan with reveals, you can increase the size of the window frame at the side by the width of the reveal. You can create the contour for your window sketch using any line type or combination of line types. ![]() Result with the selected window frames and ledgesĬombinations of Lines, Polylines and Bézier Curves Note: The parameters already specified for frame height and width are applied to the casement when a frame is selected. Window sills can only be generated for windows with a bottom edge.ĪrchiGlazing always creates an additional door or window frame inside the window sketch specified. Your settings will, however, only be used if Use Extra Frame and Windowsill Settings is selected. Under Options, specify the parameters for an additional door or window frame or window sill or ledge. Object type elements can be placed independently, they do not create an opening in a wall, will be listed as objects (and not as windows or doors) in calculations and can only be opened with the Object tool. Window and Door type elements can only be placed into walls and will create an opening there. Note: The choice you make here affects the behavior of the structure. 10.From the ARCHICAD toolbar, select the object type created (Object, Window or Door), and click to position the new window.
0 Comments
Leave a Reply. |